Table of Contents
Advertisement
LTC 2600 Series | Instruction Manual | General Commands
MR-VIDEOLOSS-OUT-ENABLE
This command returns the status (enabled/disabled) of
the videoloss relay output.
Parameter values are:
0
1
MR-WINTER-TIME <date>
This command returns the date when the time-of-day
clock will be put back by one hour (from Daylight
Saving Time back to Standard Time). At 2:00 a.m. /
02:00 on the date set, the hour is put back to 1:00 a.m.
/ 01:00.
MR-ZOOM <monitor>
This command returns the zoom setting (cameo# being
displayed and enable/disable status) for the specified
monitor.
Parameter values are:
<monitor>
1
2
<cameo#>
1 to 16
(returned value)
<boolean>
0
(returned value) 1
Bosch Security Systems | July 12, 2004
Disabled videoloss relay
output
Enabled videoloss relay
output
Monitor A
Monitor B
Disable
Enable
6
GENERAL COMMANDS
6.1
Summary of General Commands
Command
ABBR <command> <text>
AUX-OFF <camera#> <auxiliary#>
AUX-ON <camera#> <auxiliary#>
AUX-TGL <camera#> <auxiliary#>
CANCEL-AUX-LATCH <logical cam#>
DATE
!DATE
DECIMAL
DEFAULT
GET-RS-232
HEX
LATCH-AUX-OFF <logical cam#>
<auxiliary#>
LATCH-AUX-ON <logical cam#>
<auxiliary#>
PREPOS <logical cam#> <pre-position#> Sends the specified camera to the
PREPOS-SET <camera#> <pre-
position#>
R/C <logical cam#> <OpCode#> <data> Sets receiver/driver functions according to
REMOTE-TGL <camera#> <data1>
<data2>
RESET-SYSTEM
REVISION
SET-RS-232
TEVENT-TBL
TIME
!TIME
VARSPEED_PTZ <logical cam#> <pan
speed>
EN | 38
Function Description
Defines an abbreviation to be used instead
of the command string in the ASCII
protocol.
Deactivates the specified receiver/driver
camera from its specified auxiliary
function/position
Sends the specified receiver/driver camera
to the specified auxiliary function/position
Toggles the specified auxiliary
function/position on the specified
receiver/driver camera
Stops operation of a LATCH-AUX-ON or
LATCH-AUX-OFF command on the
specified receiver/driver camera
Displays the system date
Sets the system date
Selects decimal entry of numeric values
Resets all system values to the Factory
Default settings
Reads the RS-232 communication
parameters
Selects hexadecimal entry of numeric
values
"Unlatches" the specified auxiliary
function/position on the specified
receiver/driver camera
"Latches" the specified auxiliary
function/position on the specified
receiver/driver camera
specified pre-position
For the specified camera number in its
current position, sets that position as the
specified pre-position number
the parameters entered
Sets the pan/tilt/zoom functions
Resets system (simulates a power off/on
cycle)
Displays the current software revision
number
Selects RS232 communication parameters
Displays all time-event settings in an easy-
to-read table
Displays the system time
Sets the system time
Selects the variable speed functions of the
AutoDome <tilt speed> <zoom speed>
<function code> Series of dome cameras
Advertisement
Table of Contents
