Steps For Finalizing The Installation; Pilot Flame Inspection; Air Shutter Adjustment - Travis Industries DVS Insert EF II Owner's Manual

Steps for Finalizing the Installation

1. Remove the glass (see page 21).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to
be detected once it enters the firebox, ensuring gas does not build up.
3. Turn on gas to the heater. Leak test all gas joints prior to starting the appliance. Start the pilot.
Start the main burner. Leak test all gas joints again.
4. Check the pilot flame following the directions below.

Pilot Flame Inspection

The pilot flame should look like the illustration below. Adjust the pilot flame if necessary.
To adjust the pilot flame, turn this screw. Clockwise
lowers the flame while counter-clockwise raises it.
5. Install the logs (see page 23).
6. Replace the glass.
7. Check the air shutter following the directions below.

Air Shutter Adjustment

Let the heater burn for fifteen minutes (make sure the logs and glass are in place. The flames should
look like the illustration below. Adjust the air shutter, if necessary, to achieve the correct looking flame.
Move the controls left or right until the flame
looks correct. Pushing to the right gives the
flame more air, making it more blue.
Pushing to the left gives the flame less air,
making it more orange.
NOTE: If the air control is all the way open,
yet the flames remain sooty, shut off gas to
the fireplace and contact a qualified gas
service technician.
Flames should be blue at the
base, yellow-orange on the top.
© Travis Industries
Finalizing the Installation
Correct
If the flames are over 14" tall or sooty on
the ends, open the air shutter.
The pilot flame must contact the thermocouple and
thermopile (see the illustration below). Adjust the pilot up or
down as necessary.
Standard
Screwdriver
Air Shutter
NOTE: The logs must be installed correctly to
monitor the flame while adjusting the air shutter.
Not Enough Air
4060111
Too Much Air
If the flames are all blue and
short, close the air shutter.
100-01175
25