Travis Industries DVS Insert EF II Owner's Manual page 38

38
Optional Equipment
3 Follow the directions below to replace the orifices.
Use a 1/2" open end wrench
b
to unscrew the orifice.
Orifice
1/2" Wrench
4 Remove the pilot orifice following the instructions below. Replace with the propane pilot
orifice
Lift the pilot hood
a
off the pilot
assembly.
© Travis Industries
Apply thread sealant to the LP
orifices prior to installation. Use
the chart below to identify the
Manifold correct orifices.
Look here for the orifice identification
Use a hex wrench to
b
unscrew the orifice.
5/32" Hex
(for qualified installers only)
Orifice
c
LP NG
.0625 #37
Remove the orifice and replace with the LP orifice. Screw the
c
orifice all the way in and replace the pilot hood.
NOTE: when re-attaching,
this pin lines up with the
notch in the pilot hood.
4060111
Slide the air shutter all
a
the way to the left.
Manifold
d
Screw the LP orifice in so the
orifice shoulder protrudes 5/16"
(indicating full insertion).
5/16"
Orifice Identification:
LP (Propane) Orifice
35
35
NG (Natural Gas) Orifice
62
100-01175