Oce OP1030 Operation Manual page 66

2-6 System Setting
[Set up] - [Network]
• Host Name
• IP Address
• Subnet Mask
• Default Gateway
• DHCP/BOOTP
• RARP
• ARP/PING
Register the host name of the scanner (up to 32 single-byte characters) in this field.
Register the IP address of the Scanner Interface Card in this field in the following form:
XXX.XXX.XXX.XXX
Register the subnet mask of the Scanner Interface Card in this field in the following form:
XXX.XXX.XXX.XXX
Register the default gateway of the Scanner Interface Card in this field in the following form:
XXX.XXX.XXX.XXX
The DHCP and BOOTP can be set to either "ENABLE" or "DISABLE". The factory default setting is
"ENABLE".
The RARP can be set to either "ENABLE" or "DISABLE". The factory default setting is "ENABLE".
The ARP/PING can be set to either "ENABLE" or "DISABLE". The factory default setting is "ENABLE".
Page 2-13