Starting And Stopping A Recording - ESP STING Mini User Manual

To set recording mode/quality on the unit:
While STING Mini is booting up the Record's LED is solid red and the SD
Status LED is flashing green. After approximately 25 seconds, the Record
LED changes to green (if there is a media card inserted in the STING Mini,
otherwise it is red), and the SD Status LED indicates the current setting
for the recording mode, according to the following:
• Green – High
• Yellow – Medium
• White – Low
• Red – Very Low
• Blue – Audio only
Once the SD Status LED indicates the current recording mode, you have
up to 10 seconds to change it, by pressing Record button (center button).
Each time you press the button, the SD Status LED changes to a different
color, to indicate the new Recording quality mode.
If you wait more than 10 seconds, you will not be able to change
the recording quality mode. In this case, shut the unit and turn it
back on, and perform the above procedure again (this time
making sure not to wait more than 10 seconds before pressing
the center button).

Starting and Stopping a Recording

To start a recording:
1. Check that the recording readiness light is a solid green (and not
flashing Red or showing any other color).
2. Press the Record button on the device. The device will vibrate for
approximately 2 seconds and the light on the Record button will begin
to flash Red and will continue flashing for the duration of the recording
session.
3. Alternatively, press the button on the remote control cable. Both the
cable and the device will vibrate for approximately 2 seconds and the
Record button light will begin flashing.
To stop or pause a recording:
• Press the Record button either on the device or on the remote
control cable. The device will vibrate three times quickly to indicate it
is no longer recording. The Recording light returns to a solid green,
indicating that it is ready to record again.
Mini-STING User Guide
Recording with STING Mini
8