Viewing And Managing Recordings - ESP STING Mini User Manual

Alarm Indication
When the remote control cable vibrates continuously, this is an alarm. Press
the remote control button to stop the vibration.
An alarm indicates one of the following:
• The camera cable has been disconnected (lost video-sync).
• The SD card has been removed or dislodged.
• The STING Mini has suffered a severe malfunction and cannot
continue recording.
To resume recording after an alarm indication:
1. Reconnect the camera cable and/or push the SD card back in.
2. Turn the STING Mini off and on again using the On/Off button located
on the right side of the device.
3. Press the remote control button once, and keep it pressed for about
two seconds, to start recording again.

Viewing and Managing Recordings

There are two ways to view and manage recordings stored on the STING
Mini:
• Using Windows Explorer and a generic video player that supports
MPEG-2.
• Using the STING Mini Media Center (see page 12) to learn how to
operate this program).
Before you can use either of these messages, you must connect the STING
Mini, or its SD card, to the PC.
To connect the STING Mini to the PC directly:
1. Turn on the PC and the STING Mini.
2. Connect the USB cable (supplied) to the STING Mini, and then to a
USB port on the PC.
3. Wait for the device to be recognized by Windows. Usually, this is
indicated by a message box and, depending on your system
configuration, may also include a bell or other sound.
Mini-STING User Guide
Recording with STING Mini
10