Getting Started; First-Time Charging; Installing The Sting Mini Media Center - ESP STING Mini User Manual

When you receive your STING Mini, remove it from the packaging, check
that you have all the accessories (see page 2), and then follow the
instructions below. Each step is explained in more detail in a following
section.
To use the STING Mini:
1. Charge the unit.
2. Install STING Mini Media Center.
3. Set the current time.
4. Insert the SD card.
5. Connect the A/V cable to the STING Mini.
6. Connect a camera or microphone to the A/V cable.

First-Time Charging

The STING Mini ships with its battery uncharged. The first time you charge
the unit, an 8-hour charging period is required before turning the unit on.
Afterwards, the unit charges fully in approximately 3 hours.
Once the device has been charged the first time, you can connect it to the
STING Mini Media Center to set its time and date. To accomplish this, you
must install the STING Mini Media Center on a laptop or personal computer.
The Media Center is also used to view video clips and capture single
images. Details for working with the Media Center are contained in a
separate chapter later in the manual.

Installing the STING Mini Media Center

The STING Mini Media Center is an application that communicates with your
STING Mini to enable you to preview previously recorded clips, download
the clips to your computer, capture individual frames, and delete
recordings. The program also allows you to set the current date and time
used during the recording process.
For more details on using STING Mini Media Center, refer to the section,
Using the STING Mini Media
Mini-STING User Guide

Getting Started

Center.
Getting Started
4