Configuring General Settings - HIKVISION DS-7604NI-VP User Manual

User Manual of DS-7600NI Series NVR

9.1 Configuring General Settings

Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
3. In the General Settings interface, you can configure the following settings: NIC Type, IPv4 Address, IPv4
Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP
address and other network settings from that server.
Note: For the DS-7600NI-SE/N, DS-7600NI-SE/P and DS-7600NI-VP series NVR, you need to configure
the internal NIC address, so that IP addresses are assigned to the cameras connected to the PoE or built-in
switch interfaces.
The valid value range of MTU is 500 ~ 9676.
Note:
4. After having configured the general settings, click Apply to save the settings.
DS-7604&7608&7616NI-SE and DS-7600NI-V
DS-7600NI-SE/N, DS-7600NI-SE/P and DS-7600NI-VP
Figure 9. 1 Network Settings Interface
121