Download Print this page

Eagle FishEasy 350c Installation & Operation Instructions Page 13

Hide thumbs


If the transducer's face isn't parallel with the ground, remove the
transducer and ratchets from the bracket. Place the ratchets into the
holes in the bracket with the letter "B" aligned with the dot stamped in
the bracket.
Reassemble the transducer and bracket and place them against the
transom. Again, check to see if you can move the transducer so it's par-
allel with the ground. If you can, then go to step 3A.
3. Assembling the transducer.
A. One-piece bracket: Once you determine the correct position for
the ratchets, assemble the transducer as shown in the following fig-
ure. Don't tighten the lock nut at this time.
Position transducer mount on transom and mark mounting holes. Side
view shown (left) and seen from above (right).



   Related Manuals for Eagle FishEasy 350c

Comments to this Manuals

Symbols: 0
Latest comments: