Surround Assembly - Jøtul Katahdin GI 450 DV II Installation And Operation Instructions Manual

Use set screw to adjust alignment
Figure 39. Attach Surround Breastplates
Figure 40.
Attach Breastplates to Legs
2. Lay the four surround panels on the floor backside up.
Using two bolts and washers attach the right and left
upper sections (breastplates) together. See fig. 39.
3 Attach the left and right leg sections to the breast-
plate assembly using a bolt and washer on each side.
See fig. 40.
4. Four mounting tabs are attached to the back of the
surround panels at the factory. Be sure all four tabs
are in place and secure. See fig. 41.
5. Stand the assembled surround up and gently lift to
the unit. Align the mounting holes on the sides of
the insert with the mounting tabs on the surround.
See fig. 42.
8. Secure the two sections of the riser bar together with
a washer and bolt and bolt the assembled riser bar to
the surround legs as shown in fig. 43.
9. Slide the surround down into the mounting holes. Be
sure all four mounting tabs engage securely with the
adjacent bracket holes. See fig. 43.
Note: the riser bar is not used for support of the
insert- if more space is needed for the riser bar, raise
the unit using the levelling legs. See figure 37 .
10. Gently and slowly push the unit and surround back
into the fireplace. This is best done by pushing the
front outside edges of the glass frame. Reminder: Be
sure to inspect the gas line and blower cord to make
sure they are not compressed when the unit is in its
final location.
Leg
Mounting Tabs
Panel
point downward
Riser Bar Attachment
Figure 41. Surround mounting tab locations.
Figure 42. Surround engagement with firebox.
Stabilizer Bar attaches
to top of unit
Figure 43. Riser Bar installation.
See Appendix B, page 33, for Simple
Surround and Wide Surround assembly
instructions.
139177_Rev_C July 11, 2010
Leg
Panel
Engage tabs
with the
slots in the
brackets
Mounting
Tabs
Riser Bar attaches
to leg sections of
the surround
25