Surround Assembly - Jøtul Rockland C 550 CB Installation And Operating Instructions Manual

Figure 13.
Surround Panel assembly
viewed from backside.
Tools Required:
• 10 mm socket or wrench
ENAMEL CAUTION NOTE:
The assembled surround
is very heavy. Enamel
surfaces may be easily
damaged if parts strike
against each other.
Have assistance available
to help carefully attach
the surround to the
firebox and avoid contact
with the plinth assembly.
Plinth Mounting
Bracket
Figure 14. Bottom Surround Trim assembly.

Surround Assembly

All fasteners have already been installed in the
appropriate locations at the factory. You will need to
remove them, attach the parts together as described
below and reinstall the fasteners at those locations.
1. Layout the parts. Place the castings face down on
a protective surface such as carpeting, blankets or a
sheet of cardboard. See fig. 13.
2. Attach the Breastplates to each other.
Use a 10 mm socket or wrench with two M6 x 10 hex
head flange bolts. Adjust the set screw to obtain
parallel alignment of the two plates.
3. Attach the Leg plates. The Legs must be oriented with
the Hang Tabs on the inside edges as shown in fig. 13.
Use the two remaining M6 x 12 hex head flange bolts
to attach the Legs to the Breastplate assembly.
4. Attach the two Plinth half-panels together with the
single M6 x 10 hex bolt. Attach the Plinth Mounting
Bracket to the back of the Plinth assembly using the
other two M6 x 10 bolts and washers. Orient the
bracket as shown in fig. 14.
Right Leg
Hang Tabs
Right Plinth Half
Jøtul C 550 CB Rockland 139656_04
Right Breastplate
Alignment Set Screw
All fasteners are M6 x 10 mm hex
head bolts, pre-installed.
Front Grille
5. If appropriate, attach the Extended Surround Panel to
the firebox. See illustration on page 6. With the painted
side facing out, engage the hooked tabs on panel with
the slots in the backside of the Surround Brackets on the
firebox. Extend the blower power cord out beyond the
front of surround panel.
6. Attach the Bottom Trim assembly to the two studs
located in the firebox floor between the blowers using
the M6 nuts already in place.
7. Attach the Surround assembly to the Firebox.
Lift the entire assembly upright and position it in
front of the insert firebox. The four Hang Tabs on the
surround legs must engage with the adjacent cutouts
in the two adjacent support brackets on the sides of
the firebox opening. The surround will easily engage
with these brackets if the firebox is slightly proud of the
fireplace opening.
8. Check the alignment of the breastplates for "bowing"
and adjust the set screw as necessary.
9. Push the entire unit into position so that the surround is
flush against the fireplace face.
5/15/15
Left Breastplate
Left Leg
Hang
Tabs
Left Plinth Half
13