Lighting Instructions - Jøtul Katahdin GI 450 DV II Installation And Operation Instructions Manual

FOR YOUR SAFETY, READ BEFORE LIGHTING.
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
B. BEFORE LIGHTING, smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
• If your gas supplier cannot be reached, call
the fire department.
1. STOP! Read the safety information above.
2. Set the thermostat to the lowest setting.
3. Set the Burner Control Switch to the "OFF" ( )
position.
4. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
MODE CONTROLS
5. Wait five (5) minutes to clear out any gas.
Then, smell for gas, including near the
floor. If you smell gas, STOP! Follow "B" in
the safety information above on this label.
If you do not smell gas, go to the next
step.
TO TURN OFF GAS TO THE APPLIANCE:
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
CAUTION:
Do not operate this appliance
with the glass removed, cracked or broken. Replace-
ment of the glass panel shall be done by a licensed
or qualified serviceperson.

LIGHTING INSTRUCTIONS

WARNING:
LIGHTING INSTRUCTIONS
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand,
do not try to repair it. Call a qualified
technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water
.
6. Set the Burner Control Switch to the
"ON" ( ) position. The pilot will light.
PILOT LIGHT ASSEMBLY
7. Set the Burner Control Switch to the
"STAT" ( ) position for thermostatic
control.
8. Set the thermostat to the desired
setting to light the burner.
9. If the appliance will not operate,
follow the instructions "To Turn Off
Gas To Appliance", and call your
service technician or gas supplier.
3. Set the Burner Control Switch to the
"OFF" position.
4. Close control access door.
CAUTIONNER:
l'appareil si le panneau frontal en verre n'est pas
en place, est craqué ou brisé. Confiez le remplace-
ment du panneau à un technicien agrée.
139177_Rev_C July 11, 2010
Ne pas utiliser
35