Table Of Contents; Unpacking The Fireplace - Jøtul Katahdin GI 450 DV II Installation And Operation Instructions Manual

Table of Contents

Installation & Service Tools ......... 2
Unpacking the Fireplace ................ 3
Specifications ....................................4
General Information ........................ 5
Safety Information ..........................6
Installation
Fireplace Requirements .............. 7
Hearth Protection .......................... 7
Clearances ........................................9
Vent Guidelines .............................10
Masonry Fireplaces ...................... 11
Prefabricated Fireplaces ...............12
Vent Requirements .......................13
Fireplace Assembly
Gas Connection ............................. 14
Gas Pressure................................... 14
Fuel Conversion ............................. 16
High Altitude Adjustment .......... 18
Flame Picture Adjustment ......... 19
Optional Brick Panel Kits ........... 20
Log Set Installation .......................21
Wall Thermostat ........................... 23
Remote Control ........................... 23
Surround Assembly ......................24
Operation
Burner Controls ........................... 26
Blower Controls ........................... 27
System Check ................................ 27
Maintenance
Annual Cleaning ...........................28
Glass Replacement .......................28
Illustrated Part Breakdown ........ 30
Appendix A /
Wiring Diagrams,
Approved Vent Manufacturers
Appendix B /
Simple Surround
Warranty Statement ....................34
Lighting Instructions ..................... 35
...........32
......... 33

Unpacking the Fireplace

1. A Miscellaneous Hardware Kit is packed within
the firebox crate. It contains:
• Installation / Operation manual
• Fuel Conversion Kit, LP
• Leg Leveler Brackets, two each - left and right
• Leg Leveler Bolts, 4
• #10 x 1/2" Sheet metal screws, 8
• Rock Wool
2. Remove Pallet Bracket screws - two on each side.
3. Remove the Latch Tool and Stabilizer Bar which
are screwed to the pallet.
4. Use the Latch Release tool to remove the fireplace
glass frame in order to install the log set and
other accessories.
Locate the right and left spring latches on the
underside of the firebox floor. See fig. 1.
Release each latch by engaging the tangs of the
tool with the latch release, pulling it down and
forward.
Pull the Glass Frame away from the Firebox and
lift to disengage it from the retaining lip at the
top of the firebox. Set the glass out of the way.
5 The Log Set is packaged separately from the fire-
box. Do not unpack the log set until you are ready
to install it.
6. The Upper and Lower Grill panels and Surround
Panels require some assembly. See pages 24-25.
Battery Box
Figure 1. Pull each Spring Latch out and
down to disengage it from the Glass Frame.
139177_Rev_C July 11, 2010
3