Table of Contents
Advertisement
Use set screw to adjust alignment
Figure 23. Attach Surround Breastplates
Figure 39.
Attach Surround Breastplates
2. Lay the four surround panels on the floor backside up.
Using two bolts and washers attach the right and left
upper sections (breastplates) together. See fig. 39.
3 Attach the left and right leg sections to the
breastplate assembly using a bolt and washer on
each side. See fig. 40.
4. Four mounting tabs are attached to the back of the
surround panels at the factory. Be sure all four tabs
are in place and secure. See fig. 41.
5. Stand the assembled surround up and gently lift to
the unit. Align the mounting holes on the sides of
the insert with the mounting tabs on the surround.
See fig. 42.
6. Secure the two sections of the riser bar together with
a washer and bolt and bolt the assembled riser bar to
the surround legs as shown in fig. 43.
7. Slide the surround assembly down into the mounting
holes. Be sure all four mounting tabs engage
securely with the adjacent bracket holes. See fig. 43.
Note: the riser bar is not used for support of the
insert- if more space is needed for the riser bar, raise
the unit using the levelling legs. See figure 37 .
8. Carefully push the unit and surround assembly back
into the fireplace. This is best done by pushing the
front outside edges of the glass frame. Reminder: Be
sure to inspect the gas line and blower cord to make
sure they are not pinched when the unit is in its final
location.
9. Install the Safety Screen Barrier. Simply hang the
barrier assembly by engaging its hooked brackets
with the slots used by the surround panels. See figs.
42 and 43.
Leg
Mounting Tabs
Panel
point downward
Riser Bar Attachment
Figure 41. Surround mounting tab locations.
Figure 42. Surround and Safety Barrier engagement
with firebox.
Stabilizer Bar attaches
to top of unit
Figure 43. Riser Bar installation.
See Appendix B, page 33, for Simple
Surround and Wide Surround assembly
instructions.
139177-V GI 450 DVII 11/20
Leg
Panel
Engage
surround
mounting
tabs and
barrier
hooks with
the bracket
slots
Mounting
Tabs
Riser Bar attaches
to leg sections of
the surround
25
Advertisement
Table of Contents
