Surround Assembly; Air Shutter Adjustment; Rating Plate Location - Jøtul Scan 65i Installation And Operation Instructions Manual

Air Shutter Stem
Figure 29. Correct flame pattern at maximum
output. Adjust the air shutter if necessary to achieve
desired flame pattern.

Air Shutter Adjustment

The Air Shutter is set half-open at the factory. This
setting provides good combustion characteristics
with either natural gas or propane in a variety of
operating conditions. You may find, however, that
your particular installation requires adjustment to
allow for a greater or reduced air/fuel ratio. Follow
this procedure to adjust the air shutter setting.
1. Locate the Air Shutter adjustment stem extend-
ing down from the center of the firebox floor. You
will not be able to see it, however, you will be able
to feel it about 3 inches from the front of the
glass frame. See fig. 29.
2. Loosen the wingnut and pull the stem forward to
open the air inlet to allow more air into the
burner. Push it to the rear to reduce the air. Make
adjustments in 1/8" (3 mm) increments.
Between adjustments, allow the fire to burn 15 -
20 minutes on the HIGH setting, observing the
flame continuously.
3. If the flames are lazy, or sooty, move the shutter
forward to increase oxygen. If the flame appears
weak, jet-like, or blue, move the shutter back to
decrease air. Repeat the process until the flame is
as desired. Retighten the wingnut.
22

Surround Assembly

Each of the surround assemblies and front facings is
completely assembled at the factory. No further
assembly is required. All assemblies utilize hooked
brackets (fig. 30) that simply hang onto the inboard
tabs on the fireplace cabinet as shown in fig. 10 on
page 14.
• Be certain the blower power cord is routed to the
front of the insert.
• Hang the Wide Surround first, if appropriate, on
the outboard tabs on the firebox assembly.
• C C C C C ast ast ast Ir Ir Ir Ir Iron Surr ast ast on Surr on Surr on Surround: on Surr ound: ound: ound: ound: Remove the upper deflector
from the top of the firebox. See fig. 8, page 13. Lift
the surround assembly by the upper panel to
engage the hooks with the inboard hanger tabs on
the firebox assembly.
Steel F Steel F acings: acings:
• Steel F Steel Facings: Steel F acings: Open the doors and lift the assem- acings:
bly by the upper panel to engage the hanger
bracket hooks with the inboard hanger tabs.
Plinth
A plinth panel is incorporated into the Cast Iron
Surrounds. If you choose not to use it, the panel can
be removed simply by bending the panel back and
forth to snap it off of the surround backing plate.

Rating Plate Location

The Lighting Instructions / Rating Plate is tethered to
the Valve & Burner controls compartment on the left
side of the fireplace insert. Simply pull it out to
reference when operating the fireplace.
Cast Iron Surround Only: If you are installing a cast
iron surround, relocate the rating plate underneath
the firebox floor where it will be readily accessible
after the surround is hung in place.
Hanger Brackets
Figure 30. All surround panels incorporate hanger brackets
that engage with the hanger tabs on the firebox.