Resetting The Serial Converter - Allen-Bradley 1203-SSS User Manual

3-10 Configuring the Serial Converter

Resetting the Serial Converter

After you change some parameters, you must reset the serial converter
for the new setting to take effect. You can reset it by removing and then
reapplying power or by using Parameter 05 - [Reset Module].
ATTENTION: Risk of injury or equipment damage exists. If the serial
converter is transmitting control I/O to the product (indicated by a solid
!
green diamond LED), the product may fault when you remove or reset
the serial converter. Determine how your product will respond before
removing or resetting a connected serial converter.
To reset the serial converter
• Set Parameter 05 - [Reset Module] to either Reset Module or Set
Defaults. "Reset Module" will reset the serial converter. "Set
Defaults" will set all parameters in the serial converter to their
factory-default values.
Figure 3.9 Reset Module Parameter in HyperTerminal
Press the UP ARROW or DOWN ARROW key to scroll
through the parameter list. Press the LEFT ARROW or
RIGHT ARROW key to modify parameter values. Press
the ENTER key to save a new value.
5> Reset Module = Reset Module
After you enter the "Reset Module" value, the serial converter will be
reset. This parameter will then be reset to "Ready."