Removing The Serial Converter - Allen-Bradley 1203-SSS User Manual

2-2 Installing the Serial Converter
Installing the Serial Converter
1. Connect the serial converter to the product using the 1202-C10 cable.
Figure 2.2 Connecting a 1202-C10 Cable to the Serial Converter
2. Connect the converter to the computer using the 1203-SFC cable.
Figure 2.3 Connecting a 1203-SFC Cable to the Serial Converter
3. Verify that power is applied to the product. The serial converter
receives power from the product, so the product must be powered
before the serial converter will operate.
The diamond light on the serial converter flashes green to indicate that
the serial converter is properly installed and receiving power. If it is not
green, refer to

Removing the Serial Converter

ATTENTION: Risk of injury or equipment damage exists. If the serial
converter is transmitting control I/O to the product (indicated by a solid
!
green diamond LED), the product may fault when you remove or reset
the serial converter. Determine how your product will respond before
removing or resetting a connected serial converter.
1. Disconnect the 1202-C10 cable from the product and then from the
converter. To disconnect it, gently push it in and then pull it out.
2. Disconnect the 1203-SFC serial cable from the serial converter and
then the computer.
Chapter 4, Troubleshooting.