Figure 3.5 Properties Dialog Box
14. Click OK to display the HyperTerminal workspace.
TIP: Select File > Save to save the HyperTerminal configuration that
you just created. In future connections, you can select the saved
configuration and quickly connect to the serial converter.
15. Press the Enter key until the main menu appears.
Figure 3.6 Main Menu
Main Menu - Enter Number for Selection
1> Display Setup Parameters
2> Display Event Queue
3> Flash Upgrade
What do you want to do?
Edit the serial port rate, or fault action
View the event queue
View DF1 data
Update the firmware
If no text or meaningless text appears instead of the Main Menu, adjust
the baud rate in your software. Refer to
Problems
in
Chapter 4
Configuring the Serial Converter
Troubleshooting Potential
for detailed instructions.
Page
3-8
through
3-10
4-3
4-6
C-1
3-7