Configuring the Serial Converter
Chapter 3 provides information about configuring the serial converter.
Topic
Configuration Tools
For a list of parameters, refer to
Parameters. For definitions of terms in this chapter, refer to the Glossary.
Configuration Tools
The serial converter stores parameters and other information in its own
Non-Volatile Storage (NVS). You must, therefore, access the serial
converter to view and edit its parameters. The following table lists tools
that you can use to access the serial converter and edit its parameters.
Tool
DriveExplorer software
DriveTools 2000 software (version 1.xx or greater)
PowerFlex HIM
Terminal emulation software
VT100-compatible terminal
(1)
Products implementing DPI require version 2.01 or greater. Products implementing
SCANport can use version 1.01 or greater.
Appendix
(1)
Page
3-1
3-2
3-3
3-4
3-8
3-9
3-10
B,
Serial Converter
Refer To
page
3-3
in this manual
Documentation for the software
page
3-2
in this manual
page
3-4
in this manual
Documentation for the terminal
3
Chapter