Jøtul GF 370 DV Installation And Operation Instructions Manual page 17

Flame Sensor
Figure 23. Fuel conversion components and assemblies
Using a 4 mm allen wrench, unscrew the pilot
orifice. Replace it with the orifice from the kit.
Be sure the new orifice is tightly secured to pre-
vent by-pass leakage.
Replace the pilot hood by simply pushing it
back into place on its base.
8. Reinstall the Burner Plate by engaging the ven-
turi tube with the Air Shutter. BE CERTAIN THE
BURNER IS LEVEL AND SECURELY SEATED ON THE
SUPPORT LEGS ON THE FIREBOX FLOOR.
9. Replace the variable regulator. Using a Torx T-20
screwdriver, remove the two specialty screws
from the regulator tower on the front of the
valve. Note: To help identify which screws to remove,
refer to the new regulator in the kit. See fig. 23.
10. Disconnect the Regulator wire lead from the
receptacle housing terminal. Remove the regula-
tor tower and the rubber diaphragm.
Pilot Head
Ignitor
Pilot Orifice
Retainer Clip
Tab & Receptacle
Terminals
Primary Air
Injector
Regulator
Diaphragm
11. Install the new variable regulator tower from the
kit. Be sure that the gasket is properly positioned
and tighten screws securely. Connect the wire lead.
12 . Apply the identification labels to the stove so that they can
be seen by any person that may be servicing the stove.
• Label "A": Apply to front lip of the valve compartment.
• Label "B": Apply to the Rating Plate.
• Small valve sticker: Apply to valve.
13. Install the accessory panels and burner media as
appropriate. See pages 19-21.
14. Apply anti-seize lubricant to the socket head glass
frame screws before reinstalling the glass frame.
15. Apply gas to the system and check for leaks using
a soapy water solution or gas sensor.
16. Follow the System Check instructions on pages 22-23
for initial start-up and flame picture adjustment.
138914 Rev. K / 7.27.10
Shutter
Regulator
Tower
Use new Torx
screws supplied
17