Running Your Locomotive In The Trainmaster Command Environment; Cab-1 Commands For Your Locomotive - Lionel Century Club II Owner's Manual

TrainMaster Command operations

Running your locomotive in the TrainMaster Command environment

Example
Address Locomotive #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 20 volts)
Press ENG
Press 1 (the ID#)
Throttle up/press any command button

CAB-1 commands for your locomotive

Activates the keypad.
Air-release
sound.
Press AUX2 to turn
your locomotive's
headlights on and
off.
Turn the THROTTLE
to the right to
accelerate, left to
decelerate.
Press HALT to shut
down all PowerMaster
electrical output on
your railroad. Stops all
Command-equipped
Lionels in operation.
Use
HALT
Note!
emergency situations.
only in
Y our Command-equipped
locomotive comes factory-
programmed with an ID# of "1." To
get your locomotive in action, set
PowerMasters to CMD or set all power
supplies on full (no more than 20
volts). Press ENG and "1" on your
CAB-1. Turn the throttle or press any
command button; your locomotive is
ready for Command operations.
discontinue. MultiHorn \horn
sound.
Mechanical bell sound.
throttle up, and the locomotive will
accelerate in the opposite direction.
There is no neutral state.
Air-release sound.
locomotive's previous speed.
return to the previous speed.
Squealing brake sounds.
11
Press WSTL/HRN to
activate the locomotive's
horn, release it to
Press BELL once to acti-
vate the bell, again to
discontinue.
Press DIR—the
locomotive decelerates to a
complete stop; turn the
Press and hold BOOST
for extra power. Release
BOOST and return to the
Press and hold BRAKE
to slow down or stop.
Release BRAKE and
Beneath this panel
SET L M H