Running Your Locomotive In The Trainmaster Command Environment; Cab-1 Commands For Your Locomotive - Lionel Heisler Owner's Manual

TrainMaster Command operations

Running your locomotive in the TrainMaster Command environment

Example
Address Locomotive #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 20 volts)
Press ENG
Press 1 (the ID#)
Throttle up/press any command button

CAB-1 commands for your locomotive

Locomotive RailSounds effects in bold italic.
Locomotive front coupler
opens. Coupler
release sounds.
Tender rear coupler
opens. Coupler
release sounds.
Press AUX1 to activate
the numeric keypad.
Press AUX2 to turn
your locomotive's
headlight on and off.
Turn the THROTTLE
to the right to
accelerate, left to
decelerate. Speed-
dependent variable steam
chuffing. DynaChuff
dynamic chuffing effect.
Press HALT to shut down
all PowerMaster
electrical output on your
railroad. Stops all Command-
equipped Lionel locomotives in
operation.
Note!
Use HALT only in
emergency situations.
Y
programmed with an ID# of "1." To
get your locomotive in action, set
PowerMasters to CMD or set all
power supplies on full (no more
than 20 volts). Press ENG and 1 on
your CAB-1. Turn the throttle or
press any command button; your
locomotive is ready for Command
operations.
Beneath this panel
SET L M H
13
our Command-equipped
locomotive comes factory-
Press WSTL/HRN to
activate the
locomotive's whistle,
release to discontinue. Multi-
Whistle steam whistle
sound.
Press BELL once to
activate the bell,
again to discontinue.
Traditional bell sound.
Press DIR—the loco-
motive decelerates to a
complete stop; turn the throttle
up, and the locomotive moves in
the opposite direction. There is
no neutral. Steam air-
release sound.
Press and hold
BOOST for extra
power. Release BOOST
and return to the locomotive's
previous speed. Labored chuff.
Press and hold BRAKE
to slow down or stop.
Release BRAKE and return to the
previous speed. Squealing
brake sounds.