Installing The Switch On A Desktop - Allied Telesis AT-FS705L Installation Manual

Installation

Installing the Switch on a Desktop

The AT-FS705L switch can be used on a desktop or mounted on a wall. To
wall-mount the switch, refer to "Wall-Mounting the Switch" on page 13.
To install an AT-FS705L switch on a desktop, perform the following
procedure:
1. Remove all equipment from the package and store the packaging material
in a safe location.
2. If you are installing the switch on a desktop, attach the four protective
feet to the bottom on the unit. See Figure 5. Do not attach the
protective feet if you are wall-mounting the switch.
3. Place the switch on a flat, secure surface (such as a desk or table) leaving
ample space around the unit for ventilation.
4. Connect the twisted pair cables to the twisted pair ports.
Caution
Power cord is used as a disconnection device: To de-energize equipment,
disconnect the power cord. ! 7
5. Power ON the switch by plugging one end of the power cord to the back of
the switch and the other end of the power cord to a power outlet.
6. Verify that the POWER LED is green. If the LED is OFF, refer to
"Troubleshooting" on page 15 for instructions.
7. Power ON the end-nodes connected to the switch.
8. Check the LINK/ACT LEDs for each port is green. If a LED is OFF, refer
to "Troubleshooting" on page 15 for instructions.
The switch is now ready for use.
12
Figure 5 Attaching the Protective Feet