Wall-Mounting The Switch; Warranty Registration - Allied Telesis AT-FS705L Installation Manual

Wall-Mounting the Switch

The switch can be mounted horizontally on a wall using the keyholes on the
bottom of the switch. The screws, plastic anchors, and other materials
necessary to mount the switch on a wall are not provided.
To wall-mount the switch, perform the following procedure:
1. If attached, remove the rubber feet, data cables, and power cord from the
switch.
2. Select a wall location for the device.
3. Install two plastic anchors and two screws into the wall, separated by
85.34 millimeters (3.36 inches).
4. Position the switch onto the wall screws so that the ports and LEDs are
facing up.
Caution
Power cord is used as a disconnection device: To de-energize equipment,
disconnect the power cord. ! 7
5. Power ON the switch by plugging one end of the power cord to the back of
the switch and the other end of the power cord to a power outlet.
6. Verify that the POWER LED is green. If the LED is OFF, refer to
"Troubleshooting" on page 15 for instructions.
7. Connect the twisted pair cables to the twisted pair ports.
8. Power ON the end-nodes connected to the switch.
9. Check the LINK/ACT LEDs for each port is green. If a LED is OFF, refer
to "Troubleshooting" on page 15 for instructions.
The switch is now ready for use.

Warranty Registration

When you have finished installing the switch, you should register your switch
by completing the enclosed warranty card and sending it in.
AT-FS705L Switch Installation Guide
13