Installing The Switch On A Desktop; Figure 6: Attaching The Rubber Feet - Allied Telesis AT-GS950/8 Installation Manual

Installing the Switch on a Desktop

AT-GS950/8, AT-GS950/16, AT-GS950/24 and AT-GS950/48 Switches Installation Guide
You may install the AT-GS950 Switch on a desktop or in a standard 19-
inch equipment rack. To install the switch in a rack, refer to "Installing the
Switch in an Equipment Rack" on page 32.
To place the switch on a desktop, perform the following procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. Turn the switch over and place it on a table.
3. Attach the four rubber feet to the bottom of the switch as shown in
Figure 6.
Figure 6. Attaching the Rubber Feet
4. Turn the switch over again and place it on a flat, secure surface (such
as a desk or table) leaving ample space around the unit for ventilation.
5. Go to "Installing Optional SFP Transceivers" on page 37 or "Cabling
the Switch" on page 40.
31