Table of Contents
Advertisement
Disassembly
G
Removing and Replacing the Transceiver Board Assembly
G
G
26
6.
Remove the plastic side keys from the rear housing. Set the side keys aside for
reuse.
7.
To replace, insert the side keys into the rear housing.
8.
Lower the flip assembly and transceiver PCB assembly into the rear housing.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
9.
Carefully insert the side key flex on both sides of the phone into their slots.
Ensure that all the side keys operate properly.
10. Align the front housing assembly to the rear housing assembly.
11. Insert the top edge of the front housing assembly onto the rear housing
assembly.
12. Lower the bottom edge of the front housing assembly onto the rear housing
assembly.
13. Gently but firmly press the front housing assembly into final position on the
rear housing so all the edges are properly seated.
14. Hold the entire assembly carefully and turn it over to expose the four housing
screw holes.
15. Insert and tighten the two machine screws near the flip assembly to a final
torque setting of 1.5 inch pounds or 16 N/cm.
16. Insert and tighten the 2 self tapping screws into the screw holes near the
speaker assembly to a final torque setting of 1.5 inch pounds or 16 N/cm.
17. Replace the SIM, battery, and battery cover as described in the procedures.
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent ESD and component damage.
1.
Remove the battery cover, battery, SIM, and the front and rear housing
assemblies as described in the procedures.
2.
Turn the Transceiver PCB assembly and flip assembly over to expose the
display flex connector.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
3.
Use the flat end of the disassembly tool to unseat the flex connector from its
socket on the transceiver PCB assembly (see Figure 8).
March 06, 2006
U6 GSM
6809493A67-O
Advertisement
Table of Contents
