Table of Contents
Advertisement
Level 1 and 2 Service Manual
6809493A67-O
4.
Rotate the end of the transceiver PCB assembly upward at an angle. Carefully
slide the transceiver PCB assembly away from the flip assembly. Be careful
not to damage the display flex cable,
Flip Assembly
Figure 8. Removing the Transceiver PCB Assembly
5.
To replace, hold the PCB assembly at a 45 degree angle and align the
transceiver PCB assembly to the two screw bosses on the flip assembly.
6.
Lower the transceiver PCB assembly so that the screw bosses are upright with
the transceiver PCB assembly.
7.
Carefully align the display flex connector to the socket on the transceiver PCB
assembly then gently but firmly seat the connector into its socket.
8.
Replace the front and rear housing assembly, SIM, battery, and battery cover
as described in the procedures.
March 06, 2006
Transceiver PCB Assembly
B
Display Flex Connector
Disassembly Tool
Disassembly
050106o
27
Advertisement
Table of Contents
