Table of Contents
Advertisement
Level 1 and 2 Service Manual
ment
6809493A67-O
1.
Insert PCB into the Hinge Barrel opening at a 90 degree angle as shown. Use
grommet's USB recess area to align the board. Note: Hinge flex should be at
the left of the board out of the way.
Figure 47.
2.
Rotate the PCB into position connect the Hinge flex. Note: By rotating the PCB
it allows clearance for the PCB boss cutouts to clear the bosses.
Figure 48.
March 06, 2006
EL (Electroluminescent) Mylar Removal and Replace-
060291o
060309o
57
Advertisement
Table of Contents
