Step 4: Setting Up The Wireless System - Sony BDV-IT1OOOES Operating Instructions Manual

58
US
Step 4: Setting up the
Wireless System
The surround amplifier turns
off or its protection is active.
For details, see "Surround
amplifier operation"
(page 128).
The surround amplifier does
not output sound.
For details, see "Surround
amplifier operation"
(page 128).
Sound transmission is not
established.
For details, see "Surround
amplifier operation"
(page 128).
Sound transmission is
established.
To enjoy the sound by using
headphones
You can enjoy the system's sound in a place
apart from the unit by connecting the
headphones to the PHONES jack on the
surround amplifier.
When you use the multiple S-AIR
product
You can prevent miss transmission between the
S-AIR products by setting a different ID for each
S-AIR product. For details, see "Establishing
sound transmission between the unit and S-AIR
sub unit (ID setting)" (page 89).
Turns off.
Rashes green.
Turns red.
Turns green.
POWER / ON LINE Status
indicator
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
checking the POWER / ON LINE indicator of
the surround amplifier.
..
• When you connect headphones to the surround
amplifier, neither the unit nor the surround amplifier
outputs sound from the system's speakers.
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, "HP NO LINK" and
"VOLUME MIN" appear alternately in the front
panel display. Check radio reception, and set the
volume again.
S-AIR 10 switch
POWER
POWER / ON LINE
Indicator
I
--
,.-
I
I
......
--
PHONES jack
SURROUND
SELECTOR switch
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Press
1/6
on the unit.
The system turns on.
2
Make sure that the SURROUND
SELECTOR switch of the surround
amplifier is set to SURROUND.
3
Set the S-AIR 10 switch of the surround
amplifier to A.
4
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If not, check the transmission status
as follows.
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 54).
This wireless system is called "S-AIR." For
details of the S-AIR function, see "Using an
S-AIR Product" (page 89).
lie>