Step 3: Setting Up The Wireless System - Sony BDV-T20W Operating Instructions Manual

The surround amplifier does
not output sound.
The surround amplifier turns
off or its protection is active.
Sound transmission is not
established.
Sound transmission is
established.
Flashes green.
Turns off.
Turns red.
Turns green.
To enjoy sound by using
headphones
You can enjoy the system's sound by connecting
the headphones to the PHONES jack on the
surround amplifier.
For details of the surround amplifier, see
"Surround amplifier operation" (page 99).
POWER / ON LINE Status
indicator
-
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, "HP NO LINK" and
"VOLUME MIN" appear alternately in the front
panel display. Check radio reception, and set the
volume again.
• When you connect the headphones to the surround
amplifier, sound is not output from the system's
speakers.
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
observing the POWER / ON LINE indicator of
the surround amplifier.
3
Set the SURROUND SELECTOR switch
of the surround amplifier to
SURROUND.
4
Set the S-AIR ID switch of the surround
amplifier to A.
5
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If it doesn't, check the transmission
status as follows.
S-AIR ID switch
SURROUND
SELECTOR switch
POWER
POWER / ON LINE
Indicator
PHONES jack
I
CJor=c.-f--l/c9
i
t::1.=;:r::J:.c)
~~IiZ}g
() v)
0)
C::l
(if
a
iC.....~;.~.t::::.j.,t:::l
o
0
S-AIR ID switch
32
US
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Set the S-AIR ID switch of the unit to A.
2
Press I/C).
The system turns on.
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 28).
This wireless system is called "S-AIR." For
details of the S-AIR function, see "Using an
S-AIR Product" (page 61).
Step 3: Setting up the
Wireless System