Table of Contents
Advertisement
Basic troubleshooting of an amplifier is similar to troubleshooting of any other
electrical or electronic equipment. Always check the most obvious possible causes
first. To give you a few ideas of what to look for, check the following:
Problem
No power when POWER
is pressed
No sound
Sound is not precise,
lacking in bass and
stereo image
If none of these actions effect a cure, please contact your dealer, or an authorised
Musical Fidelity service agent. Remember, never open the case of the X-P100 yourself, as
this will invalidate the guarantee.
Probable Cause
Mains plug not inserted
correctly
PSU unit not connected
to main unit
Volume control is set
to minimum
Mute is selected
Preamplifier not connected
to Power amplifier
Unit has not yet come out
of power-up mute
Tape Monitor button is
depressed
Speakers are not connected,
or are connected incorrectly
Speakers are connected
out of phase
X-P100
TROUBLESHOOTING
Remedy
Plug in securely
Plug PSU umbilical lead
into back of main
X-P100 unit
Turn up the volume
Press mute button on
remote control
Check phono cable
connection between units
Wait 10-15 seconds on
power-up for unit to
un-mute
Press Tape monitor
button
Check speaker cables
Make sure that both
speakers are connected
correctly
Instructions For Use. Page 7
Advertisement
Table of Contents
