Other Programming Selections; Output Sequence Editor; Require Output Sequence - Honeywell Hyperion 1300g User Manual

Other Programming Selections

• Discard
This exits without saving any Output Sequence changes.

Output Sequence Editor

Enter Sequence
Default Sequence

Require Output Sequence

When an output sequence is Required , all output data must conform to an
edited sequence or the scanner will not transmit the output data to the host
device. When it's On/Not Required , the scanner will attempt to get the output
data to conform to an edited sequence, but if it cannot, the scanner transmits all
output data to the host device as is.
When the output sequence is Off , the bar code data is output to the host as the
scanner decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Required
On/Not Required
* Off
3 - 11