Search Commands - Honeywell Hyperion 1300g User Manual

03 is the number of characters to move the cursor
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as: 4567890ABCDEFGHIJ
Move the cursor backward a number of characters
F6 Move the cursor back "nn" characters from current cursor position.
Syntax = F6nn where nn is the numeric value (00-99) for the number
of characters the cursor should be moved back.
Move the cursor to the beginning
F7 Move the cursor to the first character in the input message. Syntax =
F7.
Move the cursor to the end
EA Move the cursor to the last character in the input message. Syntax =
EA.

Search Commands

Search forward for a character
F8 Search the input message forward for "xx" character from the current
cursor position, leaving the cursor pointing to the "xx" character.
Syntax = F8xx where xx stands for the search character's hex value for
the CP1252 character.
Refer to the
page A-2 for decimal, hex and character codes.
F8 Example: Send bar code data that starts after a particular
character
Search for the letter "D" in bar codes and send all the data that follows,
including the "D." Using the bar code above:
Command string: F844F10D
F8 is the "Search forward for a character" command
44 is the hex value for "D"
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as: DEFGHIJ
5 - 8
<CR>
ASCII Conversion Chart (Code Page 1252),
<CR>
beginning on