Honeywell Hyperion 1300g User Manual page 78

44 is the hex value for a 'D"
0D is the hex value for a CR
The data is output as: 1234567890ABC
Send all but the last characters
E9 Include in the output message all but the last "nn" characters, starting
from the current cursor position. The cursor is moved forward to one
position past the last input message character included. Syntax = E9nn
where nn stands for the numeric value (00-99) for the number of
characters that will not be sent at the end of the message.
Insert a character multiple times
F4 Send "xx" character "nn" times in the output message, leaving the
cursor in the current position. Syntax = F4xxnn where xx stands for the
insert character's hex value for the CP1252 character, and nn is the
numeric value (00-99) for the number of times it should be sent. Refer
to the ASCII Conversion Chart (Code Page 1252),
A-2 for decimal, hex and character codes.
E9 and F4 Example: Send all but the last characters, followed by
2 tabs
Send all characters except for the last 8 from the bar code above, fol-
lowed by 2 tabs.
Command string: E908F40902
E9 is the "Send all but the last characters" command
08 is the number of characters at the end to ignore
F4 is the "Insert a character multiple times" command
09 is the hex value for a horizontal tab
02 is the number of time the tab character is sent
The data is output as: 1234567890AB <tab><tab>
Insert symbology name
B3 Insert the name of the bar code's symbology in the output message,
without moving the cursor. Only symbologies with a Honeywell ID are
included (see
Conversion Chart (Code Page 1252),
decimal, hex and character codes.
5 - 6
<CR>
Symbology Chart on page A-1). Refer to the
beginning on page A-2 for
beginning on page
ASCII