Map Display With Junction View; Tunnel View - Becker GPS Navigator Operating Manual

>>> NAVIGATION MODE

Map display with Junction view

You can display a detailed and realistic
view of the lane situation at many
motorway junctions.
To do this, switch on the
function as described under "The
Guidance info button" on page 66.
If you are then directed through a motor-
way junction by the Navigation device,
you will see a corresponding display.
> Follow the lanes indicated with the
arrows.
90

Tunnel view

When your enter a longer tunnel, a three
dimensional tunnel view appears. If
there is no maneuvres performed in the
next 1000m in the tunnel, the lane of the
current road section is displayed. An
overview of the tunnel is displayed in the
bottom on the right. When you touch the
display, the tunnel view disappears. If
any maneuvres are performed in the
tunnel, or if the next maneuvre is
performed outside the tunnel, a tunnel
Junction view
view is displayed in full image mode with
the coming maneuvre.
Note:
The tunnel view and the intersection
view can be deactivated by touching the
display. The map view is displayed
again. If you would like to deactivate the
tunnel view permanently, de-select the
"Tunnel view" option in the "Settings >
Navigation settings > Route guidance"
menu.
Note:
The tunnel view provides a schematic
view of the route layout of the tunnel.
The whole tunnel layout, the first route
section and the vehicle position are
displayed. Since there is no GPS signal
during the travel through the tunnel, the
displayed position is only calculated.