Fujitsu ScanSnap iX500 Getting Started Manual page 14

Scan Test from the Mobile Device
Check that the image scanned by ScanSnap is sent to the mobile device.
1.
Start ScanSnap Connect Application on the mobile device to connect to the ScanSnap.
For details, refer to the ScanSnap Connect Application User's Guide.
2.
Load a document in the ScanSnap.
For details, refer to
3.
Press the [Scan] button on the ScanSnap.
Scanning starts. The scanned image is
displayed on the mobile device when the
scanning is complete.
If the scanned image is displayed on the mobile device, then the scanning check is complete.
ATTENTION
Depending on the ScanSnap installation location, it may take some time until the scanned image is
displayed on the mobile device. For details, refer to "Troubleshooting" in the ScanSnap Manager Help.
If the scanned image is not displayed on the mobile device after the scanning is complete, refer to the
ScanSnap Connect Application User's Guide.
"Scan Test" (page 11).
14