Troubleshooting; Led Status - AMT Datasouth Fastmark M1 User Manual

5. Troubleshooting

The following guide lists the most common problems that may be encountered when operating this
bar code printer. If the printer still does not function after all suggested solutions have been invoked,
please contact the Customer Service Department of your purchased reseller or distributor for
assistance.

5.1 LED Status

This section lists the common problems that according to the LED status and other problems you
may encounter when operating the printer. Also, it provides solutions.
LED Status
/ Color
OFF No response
Solid Green
Green with
blinking
Red with
blinking
Note:
Printer status can be easily shown on the Diagnostic Tool. For more information about the Diagnostic
Tool, please refer to the instruction in the software CD disk.
Printer Possible Cause
Status
No power
ON The printer is ready to
use
Pause The printer is paused * Press the FEED button to resume for printing.
Error The out of label or the
printer setting is not
correct
Recovery Procedure
* Turn on the power switch.
* Check if the green LED is lit on power supply. If it
is not lit on, power supply is broken.
* Check both power connections from the power
cord to the power supply and from the power
supply to the printer power jack if they are
connected securely.
* No action necessary.
1. Out of label
* Load a roll of label and follow the instructions in
loading the media then press the FEED button to
resume for printing.
2. Printer setting is not correct
* Initialize the printer by instructions in "Power on
Utility" or "Diagnostic Tool".
24