Setup; Setting Up The Printer; Media Installation; Loading Internal Media - AMT Datasouth Fastmark M1 User Manual

3. Setup

3.1 Setting Up the Printer

1. Place the printer on a flat, secure surface.
2. Make sure the power switch is set to "off".
3. Connect the printer to the computer with the provided USB cable.
4. Plug the power cord into the AC power cord socket at the rear of the printer, and then plug the
power cord into a properly grounded power outlet.

3.2 Media Installation

3.2.1 Loading Internal Media

1. Open the printer top cover by pulling the tabs located on each side towards the front of the
printer, and then lift the top cover to the maximum open angle.
2. Separate the media holders to the label roll width.
5