Figure 34: Blind Transfer - Grandstream Networks GXP2200 User Manual

Users could configure the "Default Transfer Mode" to be used on the GXP2200 under web
GUI->Advanced Settings->Call Features.
1. Blind Transfer

During the active call, press TRANSFER button

The default transfer mode is "Blind". Users could also select transfer mode by tapping on the mode
selection bar (see figure below);

Enter the digits and then press the "Send" soft key on the right;

The call will be transferred and GXP2200 will hang up the call.
Note:

If wrong digits are entered, tap on

If users would like to cancel the transfer, press
screen.
2. Auto Attended Transfer
Firmware Version 1.0.3.26
to bring up the transfer screen;

Figure 34: Blind Transfer

to delete the digit one by one;
button to go back to the previous talking
GXP2200 USER MANUAL Page 46 of 159