Maintenance/Syslog; Firmware Version 1.0.3.26 - Grandstream Networks GXP2200 User Manual

Config File Prefix
Config File Postfix
mDNS Override Server
DHCP Option 66 Override
Server
DHCP Option 120 Override SIP
Server
3CX Auto Provision
Automatic Upgrade
Automatic Upgrade Check
Interval (m)
Hour of the Day (0-23)
Day of the Week (0-6)
Automatic Upgrade Rule
Auto Reboot to Upgrade
Without Prompt
Authenticate Conf File
Factory Reset

MAINTENANCE/SYSLOG

Syslog Server
Syslog Level

Firmware Version 1.0.3.26

Enables your ITSP to lock configuration updates. If configured, only the
configuration file with the matching encrypted prefix will be downloaded
and flashed into the phone.
Enables your ITSP to lock configuration updates. If configured, only the
configuration file with the matching encrypted postfix will be downloaded
and flashed into the phone.
Allows mDNS override config/firmware server setting on the phone if
present. The default setting is "Yes".
If DHCP option 66 is enabled on the LAN side, the TFTP server can be
redirected. The default setting is "Yes".
Enables DHCP Option 120 from local server to override the SIP Server
on the phone. The default setting is "Yes".
Enables automatic provision feature on the phone when 3CX is used as
the SIP server. The default setting is "Yes".
Enables automatic upgrade and provisioning. The default setting is "No".
Specifies the time period to check for firmware upgrade (in minutes).
The default setting is 10080 minutes (7 days).
Defines the hour of the day to check the HTTP/TFTP server for firmware
upgrades or configuration files changes.
Defines the day of the week to check the HTTP/TFTP server for
firmware upgrades or configuration files changes.
Defines the rules for automatic upgrade: Always Check at bootup, when
F/W pre/suffix changes, Skip the Firmware Check.
If set to "Yes", the phone will automatically start upgrading after
downloading the firmware files. Otherwise, users would need confirm in
the prompted message in LCD to start upgrading process. The default
value is "Yes".
Authenticates configuration file before acceptance. The default setting is
"No".
Restore to factory default settings.
The URL/IP address for the syslog server.
Selects the level of logging for syslog. The default setting is "None".
There are 4 levels: DEBUG, INFO, WARNING AND ERROR. Syslog
messages are sent based on the following events:
GXP2200 USER MANUAL Page 136 of 159