Description Of The Washer Dryer - NEFF Washer Dryer Instruction Manual And Installation Instructions

Description of the washer dryer

Operation and
special features
The door
The signal
Programme state
6
Our washer dryer allows the following programmes to
be set:
- wash only
- dry only
- wash+dry
The complete wash+dry programme shifts
automatically from the wash cycle to the dry cycle
without further intervention.
Drying works on the principle of condensation. The
condensation produced during the drying cycle runs
via the drain hose to the catchment basin.
The tap must be left open and the drain hose properly
connected during drying cycles.
The washer dryer is fitted with a safety device that
prevents the door from opening while it is working.
Make sure there is no water in the tub and that the
drum is not moving.
Opening the door at the end of a programme
q Wait until End appears on the display.
q Press the Door h button on the front panel.
The acoustic signal indicates:
- pressing a button
- start of programme
- end of programme
- operating errors and faults.
q Press the I Reduced time and W Delay Start
button simultaneously to activate or deactivate the
signal. The display indicates j or i.
i The volume of the signal cannot be changed.
Press the B Spin button for approximately 5 seconds
(if the j signal is shown, a double beep will sound) to
display the programme status. The programme status
will be shown in the display, depending on the spin
speed selected.