NEFF Washer Dryer Instruction Manual And Installation Instructions page 41

Water connection
Aquasecure extension
hose
To prevent leaks or water damage, it is essential to
follow the instructions in this chapter!
Caution
Operate the washer dryer with cold drinking water
only. Do not connect the appliance to the mixer tap of
an unpressurized hot water boiler.
If in any doubt, have the water connection carried out
by an authorized technician.
The water supply hose must not be:
- Bent or squashed.
- Modified or cut through (stability can no longer be
Plastic threads must only be tightened by hand. Do
not remove the strainers from the water supply hose.
Observe the water pressure in the supply network:
- The water pressure should be between
min. 10 mm
- A pressure reducing valve must be installed if the
q Connect the water supply hose to the tap.
i In the case of a defective Aquasure hose (water
After connecting the water inlet hose:
q Turn on the tap fully.
q Check the connection points for leaks.
Available in kit form from specialist outlets:
- Connecting kit plastic hose (approx. 2.50 m),
guaranteed).
100 1000 kPa (1 ... 10 bars) (when the tap is tur
ned on, at least 8 litres of water is discharged per
minute).
maximum water pressure is exceeded. Connect
the water supply hose.
supply hose), the check eye 1 is red, for fault
report, page 32.
order no. Z7070X0.
41