Quad Chargers - Avaya 3600 Series User Manual
Ip office
Hide thumbs
Also See for 3600 Series:
- Installation instructions manual (78 pages) ,
- Configuration and administration manual (64 pages) ,
- User manual (40 pages)
Table of Contents
Advertisement
7.3 Quad Chargers
The Quad Charger is designed to simultaneously charge four Nickel Metal Hydride (NiMH) battery packs.
GCX100 is designed to charge the BPX100 Battery Pack in the 3626 phone.
·
GCN100 is designed to charge the BPN100 Battery Pack in the 3620 phone.
·
Full charging is accomplished in approximately one and a half to two hours.
To set up the quad charger, you must first obtain an appropriate Avaya power supply for your country or region.
Place the quad charger on a flat, horizontal surface and plug the power supply into the quad charger and then into an
appropriate wall outlet.
To remove, charge and replace the 3620 battery pack:
1.
To remove, press down on the latch on the battery pack on the back of the phone. The battery pack releases
outward.
2.
Insert the battery pack into one of the four charging bays so that the battery pack contacts meet the charging bay
contacts. The LED above the charging bay will turn on to indicate that charging is in progress. When charging is
complete, the LED will turn off.
3.
Lift the battery pack out of the charging bay.
4.
To replace, slide the lip of the battery pack into the bottom of the cavity and push the top of the battery pack until is
snaps into place. You should not have to force it against the phone.
To remove and replace the 3626 battery pack:
1.
To remove, hold the phone in one hand with the keypad facing up and press both battery pack release buttons (on
the left and right side of the phone) at the same time. The battery pack releases downward and you can catch it with
the palm of your hand.
If the battery pack does not release, gently shake the handset while pressing both release buttons. Do not pry.
2.
Insert the battery pack into one of the four charging bays so that the battery pack contacts meet the charging bay
contacts. The indicator light above the charging bay will turn on to indicate that charging is in progress. When
charging is complete, the indicator light will turn off.
3.
Lift the battery pack out of the charging bay.
4.
To replace, slide the battery pack straight into the cavity until it snaps into place. You should not have to force it
against the phone.
3600 Phones
IP Office
Chargers: Dual Chargers
15-601104 Issue 02b (08 September 2008)
Page 41
Advertisement
Table of Contents
