Troubleshooting - Teac TD-X300i Owner's Manual

If you have problems with your system, look through this chart and
see if you can solve the problem yourself before calling your dealer
or TEAC service center.
General
No power
e Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that, if it
is, the switch is turned on. Make sure there is power to the AC
outlet by plugging another item such as a lamp or fan into the
outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION button.
e Check the connection to the speakers.
e Adjust the volume.
e Pull out the headphone's plug from the PHONES jack.
e If "MUTING" is blinking, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances. Install the unit
apart from them, or turn them off.
Remote control doesn't work.
e Press the STANDBY/ON button (
e When the battery has run out, put in a new one.
e Use remote control unit within the range (5 m) and point at the
front panel.
e Clear obstacles between the remote control unit and the main
unit.
e If a strong light is near the unit, turn it off.
CD Player
Will not play.
e Load a disc with the playback side facing away.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded disc.
e Depending on the disc, etc. it may not be possible to play back
CD-R/RW discs. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs. Finalize such
a disc in a CD recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid vibration and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.
iPod Player
Cannot insert the iPod.
e Check the dock adapter.
e Remove dust or obstacles from the Dock connector of the TD-
X300i and the iPod, and insert the iPod again.
Will not play.
e Remove the iPod from the dock, wait a few seconds, and insert
it again.
e Software update may solve the problem. Visit the Apple
website and download the latest iPod Software.
30

Troubleshooting

) to turn the unit on.
Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e Rotate the FM or AM antenna for the best reception position.
Though the broadcast is stereo, it sounds monaural.
e Press the FM MODE button.
If normal operation cannot be recovered, unplug the power
cord from the outlet and plug it again.
If the power switch of the subwoofer turned off, the settings
kept in memory (clock, preset stations, timer setting) will be
erased.
Beware of condensation
When the unit (or a disc) is moved from a cold to a warm place,
or used after a sudden temperature change, there is a danger of
condensation; vapor in the air could condense on the internal
mechanism, making correct operation erratic or impossible.
To prevent this, or if this occurs, leave the unit for one or two
hours with the power turned on. The unit will stabilize at the
temperature of its surroundings.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or
use diluted mild liquid soap. Never spray liquid directly on this
unit. Apply your cleaner to your cleaning cloth and wipe gently.
Be sure to remove any excess completely. Do not use thinner,
benzene or alcohol as they may damage the surface of the unit.
Allow the surface of the unit to dry completely before using.