If you have problems with your system, look through this chart
and see if you can solve the problem yourself before calling your
dealer or TEAC service center.
General
No power
e Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that,
if it is, the switch is turned on. Make sure there is power to
the AC outlet by plugging another item such as a lamp or
fan into the outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION button.
e Check the connection to the speakers.
e Adjust the volume.
e Pull out the headphone's plug from the PHONES jack.
e If "MUTING" is blinking, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances. Install the
unit apart from them, or turn them off.
Remote control doesn't work.
e Press the STANDBY/ON switch to turn the unit on.
e When the battery has run out, put in a new one.
e Use remote control unit within the range (5 m) and point at
the front panel.
e Clear obstacles between the remote control unit and the
main unit.
e If a strong light is near the unit, turn it off.
CD Player
Will not play.
e Load a disc with the playback side facing away.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded disc.
e Depending on the disc, etc. it may not be possible to play
back CD-R/RW discs. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs. Finalize
such a disc in a CD recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid vibration and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.
Troubleshooting
MP3/WMA
Cannot play.
Check the MP3/WMA file extension. (see page 9)
e
MP3/WMA file data might have been broken.
e
e
The file data format might not be a MP3/WMA format
The sampling frequency of the file might be more
e
than 48 kHz.
Cannot display the file information correctly.
If a file information uses Japanese, Chinese or other
e
double-byte characters, playback is possible but the
name will not be shown correctly.
FM Tuner
Cannot listen to any station, or the signal is too
weak.
Tune in a station properly.
e
Rotate the FM antenna until you receive a station
e
clearly.
25