Wall Mounting - Teac TD-X300i Owner's Manual

You can mount the left and right speakers on a wall.
Precautions
< Be aware that the length of the cables are approximately 3 m. Do
not attempt to mount the speakers too far from the subwoofer.
< Drill holes into solid wall support, such as wooden frame or
concrete wall.
< TEAC supplies these brackets as a convenience to the product
owner. Consult your local building codes and exercise all
necessary caution when mounting these brackets. If you are
unsure how to use the supplied brackets, consult with a local
tradesmen or building supply expert.
8

Wall Mounting

To hook on the wall
1. Fix the brackets on the rear panel of the speakers using
the supplied short screws.
2. Use the supplied guide sheet to mark the exact drilling
points on the wall.
3. Drill holes in the wall at the marked points.
4. Screw the supplied long screws into the wall.
Leave about 5 mm space between the screw's head and the wall.
< As a convenience, a set of tapered plastic anchors is supplied. If
you chose to use these anchors, drill a pilot hole using a 6 mm
drill bit then tap the anchor into the pilot hole.
Only use these anchors if they are appropriate for the materials
onto which the unit is to be mounted. Consult your local
hardware store if you are uncertain.
5. Before going on, connect the speakers and the subwoofer
using the supplied speaker cables (see page 6-7).
6. Carefully hang the speakers onto the screws.
Note:
Ensure that the speaker locks onto the hooks and that the hooks
are strong enough to support the weight before removing your
hands.