Troubleshooting - Teac DC-D6800 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

Trouble Shooting
In case of trouble with the unit, please take the trouble to look through this chart and see if you can solve the problem
yourself before you call your dealer or TEAC service center.
General
No power
e Check the connection to the AC power supply.
No sound from speakers.
e Check the connection to the speakers.
e Adjust the volume.
e Select proper source.
e Pull out the headphones' plug from PHONES jack.
e If muting is on, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV set or similar
appliances. Install the unit apart from them, or
turn them off.
Remote Control Unit
Remote control doesn't work.
e If the batteries are exhausted, change the
batteries.
e Use remote control unit within the range (5m/15ft)
and point at the front panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a fluorescent light is near the unit, put it off.
Cassette Tape Deck
The cassette holder cannot be closed. TAPE buttons
don't work.
e Insert a cassette tape securely.
No sound. Sound is distorted or noisy.
e If a blank tape is in TAPE ! , change it to
prerecorded tape.
e Clean and demagnetize the heads.
Cannot record.
e If the safety tabs of the cassette tape have been
broken off, cover the holes with adhesive tape.
e Clean and demagnetize the heads.
e Use normal(Type!) or CrO
26
(Type@) tape.
2
Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e If a TV is near the unit, put it off.
e Re-orient the antenna until reception improves.
e An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e Press the STEREO/MONO button.
CD Player
Cannot play.
e Load a disc with label side up.
e If the disc is dirty, clean the surface of the disc.
One track is played repeatedly.
e Press the REPEAT button to cancel the repeat
mode.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.

Advertisement

Table of Contents
loading

Table of Contents