Handling The Remote Controller - Toshiba RAV-SM562XT-E Owner's Manual

HANDLING THE REMOTE CONTROLLER

CAUTION
• The air conditioner will not operate if curtains, doors or other materials block the signals from the remote
controller to the indoor unit.
• Prevent any liquid from falling into the remote controller.
• Do not expose the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not
function properly.
Use curtains to prevent the sunlight from reaching the receiver.
• If the room using the air conditioner has fluorescent lighting with electronic starters, signals may not be
properly received. If you are planning to use such fluorescent lamps, consult your local dealer.
• If other electrical appliances react to the remote controller, move these appliances or consult your local
dealer.
Location of the remote controller
• Keep the remote controller where its signals can reach the
receiver of the indoor unit (a distance of 7 m is allowed).
• When you select the timer operation, the remote controller
automatically transmits a signal to the indoor unit at the
specified time.
If you keep the remote controller in a position that hinders
proper signal transmission, a time lag of up to 15 minutes
may occur.
Remote controller holder
Installing the remote controller holder
• Before you actually install the remote controller holder
on a wall or pillar, check whether the remote controller
signals can be received by the indoor unit.
Mounting and removing the remote controller
• To mount the remote controller, hold it parallel to the
remote controller holder and push it in fully. To remove
the remote controller, slide the remote controller
upwards and out from the holder.
7
7 m