Handling The Remote Controller - Toshiba RAV-RM301KRTP-NZ Owner's Manual

6

HANDLING THE REMOTE CONTROLLER

• The air conditioner will not operate if curtains,
doors or other materials block the signals from
the remote controller to the indoor unit.
• Prevent any liquid from falling into the remote
controller.
Do not expose the remote controller to direct
sunlight or heat.
• If the infrared signal receiver on the indoor unit
is exposed to direct sunlight, the air conditioner
may not function properly.
Use curtains to prevent the sunlight from
reaching the receiver.
• If the room using the air conditioner has
uorescent lighting with electronic starters,
signals may not be properly received. If you are
planning to use such uorescent lamps, consult
your local dealer.
• If other electrical appliances react to the remote
controller move these appliances or consult your
local dealer.
■
Location of the remote controller
• Keep the remote controller where its signals can
reach the receiver of the indoor unit (a distance
of 7 m is allowed).
• When you select the timer operation, the remote
controller automatically transmits a signal to the
indoor unit at the specied time.
If you keep the remote controller in a position that
hinders proper signal transmission, a time lag of
up to 15 minutes may occur.
7 m
1122650203-00_S01_182x257_44p_S_p70_181006.indd 18
CAUTION
■
Remote controller holder
Installing the remote controller holder
• Before you actually install the remote controller
holder on a wall or pillar, check whether the
remote controller signals can be received by the
indoor unit.
Mounting and removing the remote
controller
• To mount the remote controller hold it parallel to
the remote controller holder and push it in fully.
To remove the remote controller slide the remote
controller upwards and out from the holder.
- 17 -
Owner's Manual
15/11/2561 8:00:36