Adjusting Clock; Handling The Remote Controller; Fan 5; Mode - Toshiba RAV-SM307KRTP-A Owner's Manual

4-2. Adjusting clock

◆ Setting the clock
Before you start operating the air conditioner, set the
clock of the remote controller using the procedures
given in this section. The clock panel on the remote
controller will indicate the time regardless of whether
the air conditioner is in use or not.
Initial setting
■
When batteries are inserted in the remote controller
the clock panel will indicate AM 0:00 and will flash.
PRESET FAN
TEMP

MODE

COMFORT
QUIET SLEEP
SWING FIX H i -POWER
1
TIMER CLR
ON OFF 2
SLEEP SET
CHK FILTER CLOCK
1
TIMER or button
ON OFF
Press the TIMER or button to set the current
ON OFF
time.
Each press of the TIMER button changes the time
in one minute steps.
Pressing the TIMER button continually changes
the time in ten minute steps.
2
SET button
SET
Press the SET button.
SET
The current time is indicated and the clock starts.
15-EN
1111056504_EN.indd 8 1111056504_EN.indd 8
Clock adjusting
■
PRESET FAN
TEMP
MODE
COMFORT
QUIET SLEEP
SWING FIX Hi-POWER
2
TIMER CLR
ON OFF 3
SLEEP SET
CHK FILTER CLOCK
1
1
CLOCK button
Press the CLOCK by tip of a pencil.
The CLOCK display flashes.
2
TIMER or button
ON OFF
Press the TIMER or button to set the current
ON OFF
time.
Each press of the TIMER button changes the time
by one minute.
Pressing the TIMER button continually changes
the time by ten minutes.
3
SET button
SET
Press the SET button.
SET
The current time is indicated and the clock starts.
4-3. Handling the remote
controller
CAUTION
• The air conditioner will not operate if curtains,
doors or other materials block the signals from the
remote controller to the indoor unit.
• Prevent any liquid from falling into the remote
controller.
Do not expose the remote controller to direct
sunlight or heat.
• If the infrared signal receiver on the indoor unit is
exposed to direct sunlight, the air conditioner may
not function properly.
Use curtains to prevent the sunlight from reaching
the receiver.
• If the room using the air conditioner has fl uorescent
lighting with electronic starters, signals may not be
properly received. If you are planning to use such
fl uorescent lamps, consult your local dealer.
• If other electrical appliances react to the remote
controller move these appliances or consult your
local dealer.
Location of the remote
■
controller
• Keep the remote controller where its signals can
reach the receiver of the indoor unit (a distance of 7
m is allowed).
• When you select the timer operation, the remote
controller automatically transmits a signal to the
indoor unit at the specifi ed time.
If you keep the remote controller in a position that
hinders proper signal transmission, a time lag of up
to 15 minutes may occur.
7 m
– 8 –
Remote controller holder
■
◆ Installing the remote controller
holder
Before you actually install the remote controller holder
on a wall or pillar, check whether the remote controller
signals can be received by the indoor unit.
◆ Mounting and removing the
remote controller
To mount the remote controller hold it parallel to the
remote controller holder and push it in fully. To remove
the remote controller slide the remote controller
upwards and out from the holder.
9/22/57 BE 3:39 PM 9/22/57 BE 3:39 PM
EN
EN
ID
16-EN